Re: Corrosion on Panasinic LED 55ET5
Ok, i will take some photos on Sunday as the TV is at my work now.
Meantime any suggestions until then are more than welcome.
Thanks a lot,
Gil
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Corrosion on Panasinic LED 55ET5
Photos of the screen or the boards?
On the screen nothing is shown now (gray, but it looks like its turned on)
The boards are clean now but before i cleaned i saw the corrosion on the components.
Leave a comment:
-
Corrosion on Panasinic LED 55ET5
Hi,
I have a corrosion on the bottom right and bottom center boards due to water that were stored there due to wrong way of cleaning the screen.
Panasonic didn't want to repair it so I tried myself.
The symptoms were vertical lines all over the screen.
I cleaned all corrosion from the boards and now nothing is shown on the screen, including the menu (I can see that the monitor is turned on).
What can I do next? Any recommendations?
Thanks,
Gil
-
Re: Plasma Panasonic 65VT60 vertical bar problem
Update, I managed to align all ribbons without removing the bottom bar.
The problem resolved, no bar anymore.
Now I need to run the scrollbar to clean the small burn that the bar left (I hope it will clean it)
Thank you all very much for the support.
Gil
Leave a comment:
-
Re: Plasma Panasonic 65VT60 vertical bar problem
One more inspection, and I think I found the root cause but need your help:
I found that C1 ribbons are offset to the right, causing bad contact as you can see in the attached images.
C2 and C3 are aligned properly.
You can see enlarged image of the ribbons and the pins of the connector.
Now I really need help of my previous question of how to disconnect the left and bottom bars so I can reach all ribbons of C1 and align them properly.
I can see that the bars are attached to the panel with some shield...Last edited by vz56098; 02-26-2015, 03:58 PM.
Leave a comment:
-
Re: Plasma Panasonic 65VT60 vertical bar problem
Hi,
I bought today the TV.
There is a black bar on the right, after it there is this colored bar. the colored bar is sometimes from top to bottom and sometimes only from top to third way to the bottom.
I opened the cover and want to remove the bottom bar to see the ribbons of C1 board.
I can't open the side bar in order to remove the bottom bar (see image)
Any suggestions? I couldn't see how in the manual...
Thanks,
Gil...
Leave a comment:
-
Re: Plasma Panasonic 65VT60 vertical bar problem
Thanks for the quick response.
The plasma belongs to a friend and he suggested to sell it to me.
As I don't have the option to open it, what are the chances of bad panel?
Does this texture of the bar is familiar/typical with ribbon disconnected?
Leave a comment:
-
Plasma Panasonic 65VT60 vertical bar problem
Hi,
I have a vertical bar in the plasma, about 7 inch wide.
You can see it in the attached photo.
Is it fixable?
Thanks,
Gil...
No activity results to display
Show More
Leave a comment: